H.B. 15
         CAREER AND TECHNICAL EDUCATION AMENDMENTS

house floor Amendments

Amendment 3 February 2, 2009 5:13 pm



Representative Don L. Ipson proposes the following amendments:

1.    Page 8, Lines 219 through 225 :    

             219          (d) (i) In addition to the members designated under Subsection (1)(b), one member of
             220      the Utah College of Applied Technology Board of Trustees, appointed by the chair of the Utah
             221      College of Applied Technology Board of Trustees, shall serve as a
{   nonvoting   }        voting       member of the

             222      board.
             223          (ii)
{   A nonvoting   }        The       Utah College of Applied Technology Board of Trustees member shall

             224      continue to serve as a member without a set term until the member is replaced by the chair of
             225      the Utah College of Applied Technology Board of Trustees.

2.    Page 13, Lines 369 through 371 :    

             369          (b) [two members]
{   one member of the State Board of Regents appointed by the   }

             370      [governor with the consent of the Senate]
{   chair of the State Board of Regents   }        the commissioner of higher education       , to serve as a

             371     
{   nonvoting   }        voting       member;


3.    Page 21, Lines 619 through 620 :    

             619          (c) offer career and technical education or basic instruction outside the geographic area
             620      served by the college campus without a cooperative agreement between an affected institution
  , except as provided in Subsection (6)       ;


4.    Page 21, Line 637 :    

             637      Technology Campus."
  (6)(a) A college campus may offer career and technical education or basic instruction outside the geographic area served by the college campus without a cooperative agreement, as required in Subsection (3)(c), if:

    (i) the career and technical education or basic instruction is specifically requested by:
    (A) an employer; or
    (B) a craft, trade, or apprenticeship program;
    (ii) the college campus notifies the affected institution about the request; and
    (iii) the affected institution is given an opportunity to make a proposal, prior to any contract

being finalized or training being initiated by the college campus, to the employer, craft, trade, or apprenticeship program about offering the requested career and technical education or basic instruction, provided that the proposal shall be presented no later than one business week from the delivery of the notice described under Subsection (6)(b).
    (b) The requirements under Subsection (6)(a)(iii) do not apply if there is a prior training relationship.  


Page 1 of 2
hb0015.hfa.03.wpd LRGC Dlarsen Dlarsen