7 LONG TITLE
8 General Description:
9 This bill modifies the Motor Vehicle Safety Inspection Act by amending provisions
10 relating to safety inspection station requirements.
11 Highlighted Provisions:
12 This bill:
13 ▸ provides that a safety inspection station permit holder shall immediately terminate
14 all safety inspection activities and return all safety inspection certificates and the
15 safety inspection station permit to the Utah Highway Patrol Division after the
16 conclusion of any adjudicative proceedings upholding a suspension or revocation.
17 Money Appropriated in this Bill:
19 Other Special Clauses:
21 Utah Code Sections Affected:
23 53-8-206, as last amended by Laws of Utah 2012, Chapter 356
25 Be it enacted by the Legislature of the state of Utah:
26 Section 1. Section 53-8-206 is amended to read:
27 53-8-206. Safety inspection -- Station requirements -- Permits not transferable --
28 Certificate of inspection -- Fees -- Unused certificates -- Suspension or revocation of
30 (1) The safety inspection required under Section 53-8-205 may only be performed:
31 (a) by a person certified by the division as a safety inspector; and
32 (b) at a safety inspection station with a valid safety inspection station permit issued by
33 the division.
34 (2) A safety inspection station permit may not be assigned or transferred or used at any
35 location other than a designated location, and every safety inspection station permit shall be
36 posted in a conspicuous place at the location designated.
37 (3) If required by the division, a record and report shall be made of every safety
38 inspection and every safety inspection certificate issued.
39 (4) A safety inspection station holding a safety inspection station permit issued by the
40 division may charge a reasonable fee for labor in performing safety inspections, not to exceed:
41 (a) $7 or less for motorcycles and street-legal all-terrain vehicles;
42 (b) unless Subsection (4)(a) or (c) applies, $15 or less for motor vehicles; or
43 (c) $20 or less for 4-wheel drive, split axle, and any motor vehicles that necessitate
44 disassembly of front hub or removal of rear axle for inspection.
45 (5) A safety inspection station may return unused safety inspection certificates in a
46 quantity of 10 or more and shall be reimbursed by the division for the cost of the safety
47 inspection certificates.
48 (6) (a) Upon receiving notice of the suspension or revocation of a safety inspection
49 station permit and after the conclusion of any adjudicative proceedings upholding the
50 suspension or revocation, the safety inspection station permit holder shall immediately
51 terminate all safety inspection activities and return all safety inspection certificates and the
52 safety inspection station permit to the division.
53 (b) The division shall issue a receipt for all unused safety inspection certificates.
Legislative Review Note
as of 1-23-15 11:54 AM
Office of Legislative Research and General Counsel