Download Zipped Amended WordPerfect HB0262.ZIP
[Introduced][Status][Bill Documents][Fiscal Note][Bills Directory]
H.B. 262
This document includes House Committee Amendments incorporated into the bill on Fri, Feb 10, 2012 at 5:04 PM by jeyring. --> 1
2
3
4
5
6
7 LONG TITLE
8 General Description:
9 This bill amends provisions relating to codes affecting buildings.
10 Highlighted Provisions:
11 This bill:
12 . updates the version of the National Electrical Code H. and the Utah Wildland Urban
12a Interface Code .H adopted by the state;
13 . reinstates a chapter of the International Building Code, as it applies to the state,
14 relating to residential energy efficiency, and deletes provisions that replaced that
15 chapter; H. [
15a . prohibits the state and political subdivisions of the state from adopting any version
15b of the International Green Construction Code; and .H
16 . modifies provisions of the International Energy Conservation Code, as it applies to
17 the state, relating to:
18 . ratings of windows, doors, and skylights; and
19 . the inspection of buildings for air leakage.
20 Money Appropriated in this Bill:
21 None
22 Other Special Clauses:
23 H. [
23a This bill provides revisor instructions. .H
24 Utah Code Sections Affected:
25 AMENDS:
26 15A-2-103, as enacted by Laws of Utah 2011, Chapter 14
27 15A-3-203, as enacted by Laws of Utah 2011, Chapter 14
28 15A-3-701, as enacted by Laws of Utah 2011, Chapter 14
29
30 Be it enacted by the Legislature of the state of Utah:
31 Section 1. Section 15A-2-103 is amended to read:
32 15A-2-103. Specific editions adopted of construction code of a nationally
33 recognized code authority.
34 (1) Subject to the other provisions of this part, the following construction codes are
35 incorporated by reference, and together with the amendments specified in Chapters 3 and 4, are
36 the construction standards to be applied to building construction, alteration, remodeling, and
37 repair, and in the regulation of building construction, alteration, remodeling, and repair in the
38 state:
39 (a) the 2009 edition of the International Building Code, including Appendix J, issued
40 by the International Code Council;
41 (b) the 2009 edition of the International Residential Code, issued by the International
42 Code Council;
43 (c) the 2009 edition of the International Plumbing Code, issued by the International
44 Code Council;
45 (d) the 2009 edition of the International Mechanical Code, issued by the International
46 Code Council;
47 (e) the 2009 edition of the International Fuel Gas Code, issued by the International
48 Code Council;
49 (f) the [
50 Protection Association;
51 (g) the 2009 edition of the International Energy Conservation Code, issued by the
52 International Code Council;
53 (h) subject to Subsection 15A-2-104 (2), the HUD Code;
54 (i) subject to Subsection 15A-2-104 (1), Appendix E of the 2009 edition of the
55 International Residential Code, issued by the International Code Council; and
56 (j) subject to Subsection 15A-2-104 (1), the 2005 edition of the NFPA 225 Model
57 Manufactured Home Installation Standard, issued by the National Fire Protection Association.
58 (2) Consistent with Title 65A, Chapter 8, Management of Forest Lands and Fire
59 Control, the Legislature adopts the H. [
59a Interface Code,
60 issued by the International Code Council, with the alternatives or amendments approved by the
61 Utah Division of Forestry, as a construction code that may be adopted by a local compliance
62 agency by local ordinance or other similar action as a local amendment to the codes listed in
63 this section.
63a H. (3) The state and a county, city, town, or other political subdivision of the state may
63b not adopt any version of the International Green Construction Code. .H
64 Section 2. Section 15A-3-203 is amended to read:
65 15A-3-203. Amendments to Chapters 6 through 15 of IRC.
66 (1) IRC, Sections R612.2 through R612.4.2, are deleted.
67 [
68
69 [
70 [
71 replaced with "35 feet (10,668 mm)".
72 Section 3. Section 15A-3-701 is amended to read:
73 15A-3-701. General provision.
74 The following [
75 applicable statewide[
76 (1) in IECC, Section 303.1.3:
77 (a) the following is added at the end of the second sentence before the period: "or, for a
78 site-built fenestration product, shall be assigned the system U-factor stated in the
79 manufacturer's documentation, if the manufacturer has produced documentation of the
80 applicable system U-factor"; and
81 (b) the following is added at the end of the fourth sentence before the period: "or, for a
82 site-built fenestration product, shall be assigned the system SHGC stated in the manufacturer's
83 documentation, if the manufacturer has produced documentation of the applicable system
84 SHGC";
85 (2) in IECC, Section 402.4.2.2:
86 (a) the following is added at the end of the first sentence before the period: "in the
87 presence of a code official"; and
88 (b) the second sentence is deleted; and
89 (3) in IECC, Section 504.4, a new exception is added as follows: "Exception: Heat
90 traps, other than the arrangement of piping and fittings, shall be prohibited unless a means of
91 controlling thermal expansion can be ensured as required in the IPC Section 607.3."
91a H. Section 4. Effective date.
91b (1) Except as provided in Subsection (2), this bill takes effect July 1, 2012.
91c (2) Section 15A-3-203 and Subsection 15A-3-701(2) take effect January 1, 2013.
91d Section 5. Revisor instructions.
91e Due to the delayed effective date of Subsection 15A-3-701(2), the Legislature intends that
91f the Office of Legislative Research and General Counsel, in preparing the Utah Code database for
91g publication, modify Section 15A-3-701 to read as follows until January 1, 2013:
91h "15A-3-701 General provision.
91i The following [
91j statewide [
91k (1) in IECC, Section 303.1.3:
91l (a) the following is added at the end of the second sentence before the period: "or, for a
91m site-built fenestration product, shall be assigned the system U-factor stated in the manufacturer's
91n documentation, if the manufacturer has produced documentation of the applicable system U-factor";
91o and
91p (b) the following is added at the end of the fourth sentence before the period: "or, for a
91q site-built fenestration product, shall be assigned the system SHGC stated in the manufacturer's
91r documentation, if the manufacturer has produced documentation of the applicable system SHGC";
91s and
91t (2) in IECC, Section 504.4, a new exception is added as follows: "Exception: Heat traps, other
91u than the arrangement of piping and fittings, shall be prohibited unless a means of controlling thermal
91v expansion can be ensured as required in the IPC Section 607.3."" .H
Legislative Review Note
as of 1-5-12 1:47 PM